4-5
Registering the Screen Data
Reference
Transmission -- Transmission in File Units
Reference
The screen data is created by using the support tool and registered to the NT600S
screen data memory. This section describes the procedure to register the screen
data to the NT600S. For the screen data creation and the support tool operation,
refer to the NT-series Support Tool Operation Manual (V028-E1-
The screen data transmission speed can be increased by setting "Hispeed" for
"Communication Mode" on the Tool Settings screen of the support tool.
The NT600S uses several screens which are switched on its display. The screen
data of one NT600S unit corresponds to the files created by using the support tool.
Select a file which contains the screen data to be transmitted when selecting the
screen data to be transmitted to the NT600S so that the required screen data can
be transmitted to the NT600S.
Screen data file
Screen 1
Screen 2
:
All screen data are
Screen N
transmitted by one operation.
Memory table
Mark data
System memory
Direct connection information
If an error message and the System Menu are displayed immediately after the
NT600S has been started, the screen data memory needs to be initialized.
Before transferring the screen data to the NT600S, initialize the image data
memory.
Section 3-5
).
NT600S
Screen 1
Screen 2
:
Screen N
Memory table
Mark data
System memory
Direct connection information