Selecting The Automatic Reset Function - Omron NT-series Operation Manual

4-6-5

Selecting the Automatic Reset Function

[ MEMORY SWITCH MENU (2/2) ]
Automatic Reset
Data Bit Length
Stop Bit Length
Parity Bit
FlowControl
RS-232C Speed
"Automatic Reset"
"Data Bit Length"
"Stop Bit Length"
"Parity Bit"
"Flow Control"
"RS-232C Speed"
To set and quit the menu, press the [SAVE EXIT] touch switch. To quit without set-
ting, press [EXIT].
The "Automatic Reset" memory switch in MEMORY SWITCH MENU 2 selects
whether or not operation is automatically restarted after the occurrence of a com-
munication error.
The factory setting for the automatic reset function is "OFF".
Select whether the automatic reset function is off or on by operation from the Sys-
tem Menu as described below.
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
The setting changes when each
of the touch switches is pressed
EXIT
are indicated below.
ON
7bits
PREV.
2bits
PAGE
Odd
SAVE
XON/XOFF
EXIT
19200bps
Alternates between "OFF" and "ON"
Alternates between "8 bits" and "7 bits"
Alternates between "2 bits" and "1 bit"
Changes among "None", "Even" and "Odd"
Changes among "None", "RS/CS"
and "XON/XOFF"
Changes among "2400 bps", "4800 bps",
"9600 bps" and "19200 bps"
Select "Maintenance Mode".
Section 3-6