Touch Switch Disable; Touch Switch Enable - Omron NT-series Operation Manual

    &
Description
Disabling/Enabling the Touch Switch Input

Touch Switch Disable

Format
Description
Reference

Touch Switch Enable

Format
Description
Reference
Enquires the status of a lamp or touch switch specified by its address.
The NT600S returns the Lamp and Touch Switch Display Status Response Com-
mand (refer to 7-3 Lamp and Touch Switch Display Status Response ) to report the
display status.
It is possible to enable or disable input from the touch switches on the displayed
screen.
The following commands are used for this control.
m : Switch whose input is to be disabled.
1
0 (30 ): Touch switches
H
2 (32 ): Touch switches
H
Disables touch switch and function key input and notification to the Host.
Use the Touch Switch Enable Command (refer to 7-2-3 Touch Switch Enable ) to
use a disabled touch switch again. Disabled touch switches are also enabled
when the NT600S power is turned off.
m : Switch whose input is to be enabled.
1
0 (30 ): Touch switches
H
2 (32 ): Touch switches
H
Enables input and notification to the Host of a disabled touch switch or function
key.
Disabled touch switches are also enabled when the NT600S power is turned off.
[ESC] U m
1



1B 55
[ESC] V
m
1



1B 56
Section 6-2