Making The Cable For Connection To The Support Tool; Wiring Connections - Omron NT-series Operation Manual

.(            

Making the Cable for Connection to the Support Tool

Make the connection cable for connection to the support tool by referring to the following explanation.
Parts Required
The table below indicates the recommended parts for making the connection cable.
Name
Connector XM2A-2501
XM2A-0901
XM2D-0901
Connector cover XM2S-2511
XM2S-0901
Cable AWG28
IFVV-SB


CO-MA-VV-SB
5P
The recommended parts listed above are those applicable when the personal computer features a 25-pin DSub
female connector. If the personal computer features another type of connector, prepare the appropriate parts by
referring to its manual.

Wiring Connections

The connector at the NT600S used for connecting the support tool is also used as the connector for connecting the
PC/Host.
For the pin configuration, refer to NT600S Connector Specifications (page 267).
The wiring connection is shown below.

With a 25-pin Connector
NT600S
RS-232C
interface
Note
APPENDIX H
Model
25-pin, manufactured by OMRON
9-pin (Plug), manufactured by OMRON
9-pin (Socket), manufactured by OMRON
25-pin, manufactured by OMRON
9-pin, manufactured by OMRON


5P Multicore cable, manufactured by Fujikura, Ltd
Multicore cable, manufactured by Hitachi Cable, Ltd
28AWG
Abbrevi- Pin
ation number
FG 1
SD 2
RD 3
RS 4
CS 5
+5V 6
-- 7
-- 8
Shielding
SG 9
wire
For some host computers the combination of pin numbers and signal names may
differ from those shown in the diagram above. Refer to the Host instruction manu-
al before wiring the connector.
Remarks
PC (RS-232C 25pin connector)
Pin Abbrevi-
number ation
1
FG
2
SD
3 RD
RS-232C
4 RS
interface
5 CS
6 --
7 SG
8
--
--
--
--
--
-- --
-- --
20 ER
Appendix H