Connecting The Nt600S - Omron NT-series Operation Manual

    $   & ' (
Units with Built-in Host Link Function
PC Series PC Series
Host Link Unit
CV500-LK201
CV series CV i
CV500-LK201
(*) (*)
CV500-LK201
CVM1 series
CV500-LK201
(*)
* : Connection is not possible to the CPU units of CVM1/CV series PCs that do not have the suffix "-EV
In the case of these CPU units, make the connection to NT600S by using a host link unit.
3-4-2

Connecting the NT600S

Caution
Connecting to a PC with a 25-pin Connector
CPU Unit
CV500-CPU01-EV1
CV1000-CPU01-EV1
CV2000-CPU01-EV1
CVM1-CPU01-EV1
CVM1-CPU11-EV1
CVM1-CPU11-EV2
CVM1-CPU21-EV1
Refer to the illustrations below to select the appropriate cable for the unit connec-
tors and connect the NT600S to the PC.
To make a connector cable, refer to Appendix E Method for Making the Cable for
Connection to the PC/Host (page 264).

After connecting a communication cable, always secure it with the screws.
Otherwise the cable may disconnect, causing operation to fail.

The cable's tensile load is 30 N. Do not subject it to loads greater than this.
Otherwise a discontinuity may occur, causing operation to fail.
Use a connector cable with a 25-pin connector on one end and a 9-pin connector
on the other end (NT600S side) to connect the NT600S to a PC with a 25-pin con-
nector.
NT600S
9-pin connector
RS-232C connector cable
Use the following recommended cables (OMRON);
Connector
Specification
XW2Z-200S
25 pin to 9 pin 25-pin to 9-pin
XW2Z-500S
CPU Units Connectable Using an CPU Units Connectable Using an
Expansion Communication Board
Host link unit/CPU unit
Host I/F connector
(RS-232C 9-pin type)
Type Cable Length
2m
5m
Section 2-4
Connectable to Connectable to
CV500
CV1000
CV2000
CVM1


".
SYSMAC C series
PC, CVM1/CV
series PC
25-pin connector
Applicable
Host Link Unit
C500-LK203
C500-LK201-V1
C120 LK201 V1 C120-LK201-V1
C200H-LK201
CV500-LK201