Using Numeric Keys - Omron NT-series Operation Manual

   
5-8-4

Using Numeric Keys

Selecting the Numeral Setting Area for Data Input
To input numerical data at a numeral setting area during operation, first select the
numeral setting at which the data is to be input, and then input the numerical value
by pressing the numeric keys (touch switches).
Select the numeral setting area into which the numerical value is to be input by
using either the numeric keys or the system keys.

Selection with the numeric keys
Use the [HOME], ,
shifted between numeral setting areas in the way shown in the figure below.
6563
HOME
4568
5107
Pressing the [HOME] key will shift the cursor to the area whose top left corner
has the smallest XY coordinate sum (the top left numeral setting input field in the
example above).

Selection with the system keys
When the and system keys on the touch panel are pressed, the cursor
moves between the numeral setting areas by following the order in which they
were created using the support tool.
For example, if three numeral setting areas have been created, the cursor can
be moved between them following the order of creation as follows.
key:1st area 2nd area
key:1st area 3rd area
If the "numeral setting" screen attribute is set to "system", the order of cursor
motion when the and
refer to the NT series support tool operation manual (V028-E1-
, and keys. By using these keys, the cursor can be
3200
0000
4624
3rd area 1st area
2nd area 1st area
system keys are used can be changed. For details,
Section 4-8


).