Checking The Pt Setting Status - Omron NT-series Operation Manual

  .  
Note
4-9-3

Checking the PT Setting Status

Checking the PT setting Status
[ I/O CHECK MENU ]
Quit
LED
Buzzer
T ouch Switch
LCD Display
[ DIP-SWITCH STATUS ]
1.Forced Memory Init.
2.Language
3.Mode Change
4.Reserved
5.Reserved
6.Reserved
7.Reserved
8.Battery Low Check
1 2 3
EXIT

To exit the DIP switch settings display, press the "EXIT" touch switch.
If the DIP switch settings have been changed when the NT600S is powered, reset
the power to the NT600S. The changes with the DIP switches become effective
only after the power supply is reset.
Display the NT600S settings by using the menu operation from the System Menu
as mentioned below.
[ SYSTEM MENU ]
Quit
Transmit Mode
Maintenance Mode
Select "DIP-Switch".
Backlight
Communication I/F
DIP-Switch
The NT600S DIP switch sta-
OFF
tuses are displayed.
English
Enable
OFF
4 5 6 7 8
ON
OFF
Select "Maintenance Mode".
Section 3-9