Trane IntelliPak Signature Series Programming Manual page 71
Commercial self-contained signature series, 20-80 ton modular series, 20-35 ton, “ao” and later design sequence
Hide thumbs
Also See for IntelliPak Signature Series:
- Installation, owner, and diagnostic manual (109 pages) ,
- Programming manual (52 pages)
Table of Contents
Advertisement
PKG-SVP01B-EN
Programming
(On units with GBAS)
GBAS 0-5 VDC Module Relay Outputs
#1 OFF #2 OFF #3 OFF #4 OFF #5 OFF
Factory Presets: Off
Possible Values:
1, 2, 3, 4, 5 = On, Off
1. Press the NEXT key again to display the following screen.
Status/Annunc Test
Heat: OFF
Cool: OFF
Factory Presets: Off
Possible Values:
Heat = On, Off
Cool = On, Off
Service = On, Off
1. Press the NEXT key to advance the cursor to the next field within this screen.
2. Press the NEXT key again to display the following screen.
Start Test In
Press TEST START To Begin, STOP To Halt
1. Press the NEXT key to advance the cursor to the next field within this screen.
2. Press the NEXT key again to display the following screen.
SERVICE MODE
Sys On (Blinking)
Service: OFF
5 Seconds
71
Hide quick links:
Advertisement
Table of Contents
