Trane IntelliPak Signature Series Programming Manual page 18

18
Programming
(On units with electric heat only)
Electric Heat
Stage 1 OFF
Possible values: Off, On
Note: Two or three-stage electric heat is a field-provided option.
1. Pressing the NEXT key will display the following screen.
(On units with hydronic heat only)
Hydronic Heat
Low Air Temp Limit
Possible values: Hydronic Heat = Enabled, Disabled
Valve position = 0-100% open
Low temp air = OK , tripped
1. Pressing the NEXT key will display the following screen.
(On units with VCM module or Traq™ damper option only)
Active Min OA Flow Setpoint
OA Flow 350.0 CCFM
Possible values: Unit Airflow = 0 to maximum unit airflow
1. Pressing the NEXT key will display the following screen.
(On units with VCM module and CO2 reset enabled)
Active Min OA Flow Setpoint
C02 Level 1512 PPM
Possible values: Unit Airflow = 0 to maximum unit airflow
1. Pressing the NEXT key will display the following screen.
(On units with VCM module and preheat enabled)
OA Preheat Output Control:
Possible values: On, Off
1. Pressing the NEXT key will display the following screen.
End of Submenu (NEXT) to Enter SETUP
1. Pressing the NEXT key will display the following screen.
Compressor Status Submenu
Press ENTER to View Data in This Submenu
1. Pressing the NEXT key will display the following screen.
STATUS
ENABLED
Stage 2 OFF Stage 3 OFF
ENABLED
OK
342.0 CCFM
OA Damper Pos
342.0 CCFM
OA Damper Pos
ON
0 %
0 %
0 %
PKG-SVP01B-EN