Trane IntelliPak Signature Series Programming Manual page 30
Commercial self-contained signature series, 20-80 ton modular series, 20-35 ton, “ao” and later design sequence
Hide thumbs
Also See for IntelliPak Signature Series:
- Installation, owner, and diagnostic manual (109 pages) ,
- Programming manual (52 pages)
Table of Contents
Advertisement
30
Programming
(On units with an airside economizer and comparative enthalpy only)
Active Outside Air Humidity
ECEM Return Air Humidity
Possible Values:
1. Pressing the NEXT key will display the following screen.
(On units with a VCM)
VCM Outside Air Flow Input
Possible Values:
0 to max unit airflow.
1. Pressing the NEXT key will display the following screen.
(On units with a VCM installed and CO2 reset enabled)
VCM CO2 Level Input
Possible Values:
1. Pressing the NEXT key will display the following screen.
(On water-cooled units with a water flow switch installed)
WSM Water Flow Switch Input
Possible Values:
1. Pressing the NEXT key will display the following screen.
End of Submenu (NEXT) to Enter SETUP
1. Pressing the NEXT key will display the following screen.
(On units with GBAS module)
GBAS 0 - 5VDC Module Status Submenu
Press ENTER to View Data in This Submenu
1. Pressing the NEXT key will display the following screen.
STATUS
0-100%
350.0 CCFM
1512 PPM
0-2000 PPM
Flow, No Flow
30 %
62 %
Flow
PKG-SVP01B-EN
Hide quick links:
Advertisement
Table of Contents
