Trane IntelliPak Signature Series Programming Manual page 42

42
Programming
(On units with Traq™ dampers only)
For Outside Air Preheat Ctrl, Use Sensor
Connected To:
Possible Values:
1. Pressing the NEXT key will display the following screen.
Monitor Specific Temp Input, Use Sensor
Connected To:
Factory Presets: RTM Zone Temp Input
Possible Values:
1. Pressing the NEXT key will display the following screen.
End of Submenu (NEXT) to Enter SETUP
1. Pressing the NEXT key will display the following screen.
Outside Air Ventilation Setup
(On units with a VCM or airside economizer)
Outside Air Ventilation Setup Submenu
Press ENTER to Review or Adjust
1. Pressing the NEXT key will display the following screen.
(On units with an airside economizer and IGV or VFD)
OA Flow Compensation Function:
Use Fixed OA Damper Minimum Position
Possible Values:
Enabled 2nd line = "OA Damper Min Pos Depends on IGV/VFD Pos"
Disabled 2nd line = "Use Fixed OA Damper Minimum Position"
1. Pressing the NEXT key will display the following screen.
SETUP
VCM MODULE AUX TEMP INPUT
VCM Module Aux Temp Input
WSM Mixed Air Temp Input
RTM ZONE TEMP INPUT
RTM Zone Temp Input
NSB Zone Sensor
RTM Aux Temp Input
Heat Module Aux Temp Input
ECEM Return Air Temp Input
No Sensor Selected
DISABLED
Enabled, Disabled
PKG-SVP01B-EN