Trane IntelliPak Signature Series Programming Manual page 28
Commercial self-contained signature series, 20-80 ton modular series, 20-35 ton, “ao” and later design sequence
Hide thumbs
Also See for IntelliPak Signature Series:
- Installation, owner, and diagnostic manual (109 pages) ,
- Programming manual (52 pages)
Table of Contents
Advertisement
28
Programming
(On units with hydronic, electric, or external heat only)
Temp Measured By Sensor Connected To
HEAT MODULE AUX TEMP INPUT
1. Pressing the NEXT key will display the following screen.
(On units with a VCM and OA preheater enabled)
Temp Measured By Sensor Connected To
ECEM RETURN AIR TEMP INPUT
1. Pressing the NEXT key will display the following screen.
(On water-cooled units only)
Temp Measured By Sensor Connected To
WSM ENT WATER TEMP INPUT
1. Pressing the NEXT key will display the following screen.
(On water-cooled units only)
Temp Measured By Sensor Connected To
WSM MIXED AIR TEMP INPUT
1. Pressing the NEXT key will display the following screen.
(On water-cooled units only)
Temp Measured By Sensor Connected To
WSM ENT COND WATER TEMP INPUT
1. Pressing the NEXT key will display the following screen.
(On units with a VCM installed and O/A preheater enabled)
Temp Measured By Sensor Connected To
VCM MODULE AUX TEMP INPUT
1. Pressing the NEXT key will display the following screen.
Compressor Module Ckt 1
Evap Temp 75.0
1. Pressing the NEXT key will display the following screen.
Compressor Module Ckt 2
Evap Temp 72.0
1. Pressing the NEXT key will display the following screen.
STATUS
82.0 F
78.0 F
60.1 F
51.7 F
64.9 F
50.0 F
Sat Cond Temp 81.0 F
Sat Cond Temp 87.0 F
PKG-SVP01B-EN
Hide quick links:
Advertisement
Table of Contents
