Trane IntelliPak Signature Series Programming Manual page 19
Commercial self-contained signature series, 20-80 ton modular series, 20-35 ton, “ao” and later design sequence
Hide thumbs
Also See for IntelliPak Signature Series:
- Installation, owner, and diagnostic manual (109 pages) ,
- Programming manual (52 pages)
Table of Contents
Advertisement
PKG-SVP01B-EN
Programming
Compressor Relay K11
Enabled
Possible values: K11 = Off, On, Locked, Disabled, Enabled
Disabled by:
Compressor Protection
Contactor Failure
Low Pressure Cutout
Bad Cond Temp Sensor
Demand Limit
Low Ent Cond water Temp
1. Pressing the NEXT key will display the following screen.
(On units with manifolded refrigerant circuits)
Compressor Relay K12
Enabled
Possible values: K11 = Off, On, Locked, Disabled, Enabled
Note: On models SCWF/SIWF and SCRF/SIRF units, K12 is the "B" compressor on units
with manifolded refrigerant circuits and "C" compressor on all units with independent
refrigerant circuits. Check unit model number, digit 5 to determine which type circuit the
unit has.
1. Pressing the NEXT key will display the following screen.
(On units with independent refrigerant circuits)
Compressor Relay K3
Enabled
Possible values: K3 = Off, On, Locked, Disabled, Enabled
Note: On models SCWF/SIWF , 35-80 tons, K3 is the "B" compressor.
1. Pressing the NEXT key will display the following screen.
(On model SCWF/SIWF , 60-80 ton units)
Compressor Relay K4
Enabled
Possible values: K4 = Off, On, Locked, Disabled, Enabled
Disabled by:
Compressor Protection
Contactor Failure
Low Pressure Cutout
Bad Cond Temp Sensor
Demand Limit
Low Ent Cond Water Temp
1. Pressing the NEXT key will display the following screen.
STATUS
OFF
Frost Protection
Tracer Summit
®
Lockout
Minimum Off Time
Low Ambient Lockout
Ventilation Override
OFF
OFF
OFF
Frost Protection
Tracer Summit
®
Lockout
Minimum Off Time
Low Ambient Lockout
Ventilation Override
19
Hide quick links:
Advertisement
Table of Contents
