Unimount- / Decor-Style Panels And Bb-Mtp Back Box (Plasterboard) - AMX Color Active-Matrix LCD Instruction Manual

Note
Refer to Wiring the Mini-
Touch Panel subsection for
pinout descriptions.
Note
Once attached to the Decor-
style faceplate, the security
screws can't be replaced
without removing the overlay.
Figure 12
UniMount- / Decor-style touch
panels
12 Installing Mini-Touch Panels
8.
Thread the incoming AXlink and optional video wiring through the BB-MTP
knockouts.
9.
Fasten the BB-MTP to the solid surface using the supplied mounting screws.
10.
Connect the AXlink and optional video wiring to the mini-touch panel. Refer to
Wiring the Mini-Touch Panels for wiring diagrams and pinout descriptions.
11.
Test the connection by reconnecting the AXlink connector to the Central Con-
troller and optional video wiring to the video source. The panel beeps when you
apply power.
12.
Disconnect the above connections until the installation of the panel is complete.
13.
Fasten the mini-touch panel to the BB-MTP using the #6-32 screws supplied with
the panel.
14.
Place the UniMount backing plate or Decor-style faceplate onto the bezel. You
can optionally secure the Decor faceplate to the bezel using the four Phillips flat-
head security screws.
15.
Remove the backing from the adhesive tape strips on the touch panel.
16.
Press the engraved overlay onto the UniMount or Decor-style faceplate.
17.
Reconnect the AXlink and video wiring to the mini-touch panel. Refer to Wiring
the Mini-Touch Panels for wiring diagrams and printout descriptions. The touch
panel will beep when you apply power.

UniMount- / Decor-style panels and BB-MTP Back Box (plasterboard)

These instructions describe how to install the UniMount- / Decor-style touch panels
listed in Figure 12.
UniMount- / Decor-style touch panels
UniMount Decor-style
AXU-MCA (/PB) AXD-MCA (/PB)
AXU-MCV (/PB) AXD-MCV (/PB)
Figure 13 shows a sample AXD-MCV/PB and BB-MTP UniMount Back Box for plas-
terboard.
1.
For UniMount–style (AXU) touch panels, cut out the surface using the dimen-
sions shown in Figure 14. For Decor-style (AXD) touch panels, cut out the surface
using the dimensions shown in Figure 15.
Color Active-Matrix LCD Mini-Touch Panels