Setting The Channel Code - AMX Color Active-Matrix LCD Instruction Manual

Note
If DEVICE USED is set to 4
and Base Device Number is
128, the Central Controller
recognizes bus devices 128,
129, 130, and 131.
Figure 53
CHANNEL code buttons
Note
The panel will not allow you to
enter a device number greater
than the DEVICE USED with-
out first displaying a decision
box. This box asks you to de-
cide whether you accept the
new selection or default to the
previous value.
Note
The channel code for non-
active buttons is 0 and for
active buttons is 1 through
255.
Note
If DEVICE USED is set to 4
and Base Device Number is
128, the Central Controller
recognizes bus devices 128,
129, 130, and 131.
38 Designing Touch Panel Pages
2.
Press 3D RECTANGLE 1 to set the button border to 3D RECTANGLE 1 style and
return to the Button Properties page. The BORDER button in the Button Proper-
ties page changes to show the active border type. In this case, the button changes
to the 3D-rectangle border.

Setting the channel code

The channel buttons that set the device and button channel codes for the touch panels
are shown in Figure 53. Refer to Figure 159 for more information on DEV and CHAN.
1.
Press DEV to open the keypad and set the touch panel's device number.
2.
Enter 1, 2, 3, or 4 in the keypad. The AXCESS software program uses device
codes 1 through 4 to identify the touch panel. Refer to the Touch Panel Program
Reference section for detailed information.
3.
Press ENTER to store the device number into memory, close the keypad, and re-
turn to the Button Properties page.
4.
Press CHAN to open a keypad and enter a channel value of 1 through 255 in the
keypad. The AXCESS software program uses the channel code number to iden-
tify the button and its' programmed operations.
5.
Press ENTER to store the channel number in memory, close the keypad, and re-
turn to the Button Properties page.
Color Active-Matrix LCD Mini-Touch Panels