Installation
Mounting the Touch Panel
The following paragraphs describe mounting the Decor and rack-mount touch panels. TiltScreen
touch panels can be placed on any flat surface.
Decor style panels with low-profile Backboxes
1. Cut out the surface using the dimensions shown in FIG. 1.
FIG. 1 Decor style and low-profile Backbox output dimensions
2. Carefully insert a flat-blade screwdriver into the release slot on the touch panel's faceplate and
remove the engraved overlay.
3. Place the touch panel into the cutout and mark the screw insert positions, as shown in FIG. 1.
4. Remove the touch panel and drill four #6-32 insert holes. Then, place a threaded insert into
each hole.
5. Disconnect the AXlink connector from the Central Controller and the optional RS-232 wiring
from the external RS-232 device connected to the source equipment.
6. Thread the AXlink connector and optional RS-232 wiring through the low-profile Backbox.
8.5" Black and White Touch Panels
Installation
3