Installation; Mounting Decor-Style Panels; Mounting The Decor-Style Panel Into A Pre-Walled Conduit Box (Cb-Cp4) - AMX AXD-CP4/PB Instruction Manual

Installation

Mounting Decor-style Panels

The following paragraphs describe mounting the Decor-style touch panels using the different types
of available methods and surfaces. The CP4 has an AXlink and DB-9 port on the rear of the unit.
Communication can be done through either the AXlink or DB-9 cables. These steps use AXlink for
both data and power.

Mounting the Decor-style panel into a pre-walled conduit box (CB-CP4)

The CP4 Conduit/wallbox is an optional metallic housing that is installed onto a beam in a pre-wall
setting. The CP4 is housed in a plastic backbox (CB-CP4) that comes shipped with the unit.
To install Decor-style touch panels:
1. Carefully remove the Decor faceplate (A in FIG. 2) and plastic pushbuttons from the main
AXD unit (B in FIG. 2) by gripping the faceplate from the notches (located along the underside
of the plate) and pulling with gentle force.
Do not remove the illumination board from the main unit. Damage to any pins
prevents proper operation of the unit.
2. Remove any necessary wiring cutouts from the pre-installed (optional) conduit/wallbox
(C in FIG. 2) (CB-CP4) where the AXlink cable is threaded through for connection to the
touch panel (FIG. 2). The snaps located along the side of the conduit/wallbox can be snapped
off or used to mount the unit to a hard surface (like a wooden beam).
Install the (2) #4-40
indicated by the
A - Decor
faceplate
FIG. 2 Decor-style panel installation configuration for pre-existing conduit/wall box
4" Color Touch Panels
C - Optional CB-CP4
into the places
drawing
conduit/wallbox
B - Main AXD unit consists of
the illumination board,
touch panel, and plastic housing
Illumination board
Installation
Cable
knockouts
Removable
tabs
3