Table of Contents
Advertisement
Note
This SMT-PKM page provides
information about the Smart-
Pack. The only setting which
can be changed is the SLEEP
TIMEOUT for the touch panel.
Figure 103
SMT-PKM page
Note
Refer to the Wireless status
(optional WAV-PKM) subsec-
tion for information on how to
set the RF and IR.
68
Touch Panel Program Reference
Wireless status (optional SMT-PKM)
The WIRELESS STATUS button appears on the Setup page when a SmartPack is con-
nected to the touch panel. Press the WIRELESS STATUS button to open the optional
page shown in Figure 103.
Refer to the SmartPacks for TiltScreen Touch Panels instruction manual for detailed in-
formation. The Mini-SmartPack page shows the following information:
SLEEP TIMEOUT
minimum time-out is 1 minute and maximum is 120 minutes. When the
panel goes to sleep, all communication and battery discharge stops. If the
time-out is set to 5, the panel goes into sleep mode if there is no activity for 5
minutes. The panel wakes up when you touch the screen.
Smart-Pak Not Locked/Locked
is connected to the panel. Not locked indicates the panel is not communicat-
ing with the AXR-RF RF receiver. Locked indicates the panel is locked on to
the AXR-RF connected to the Central Controller.
Battery Voltage XX.X
able battery in the SMT-PKM.
Module Version vX.XX
SMT-PKM.
Fully Charged/Not Charging/Charging
the battery in the SMT-PKM is fully charged. Not Charging appears when
Press the UP and DN buttons to set the time-out. The
Appears when an optional SMT-PKM
Shows the voltage level of the lead-acid recharge-
Shows the firmware version installed in the
Fully Charged appears when
Color Active-Matrix LCD Mini-Touch Panels
Advertisement
Table of Contents
