Axu-Mlc (/Pb) And Bb-Mtp (Plasterboard) - AMX LCD Mini-Touch Panels Instruction Manual

Note
The mini-touch panel must
always be installed with the
release slot located at the
bottom.
Figure 8
AXU-MLC (/PB) and BB-MTP
for plasterboard
Black/White LCD Mini-Touch Panels
Thread the incoming AXlink and RS-232 wiring through the BB-MTP knockout.
8.
Fasten the BB-MTP to the solid surface with the mounting screws supplied with
9.
the enclosure.
Connect the AXlink and RS-232 wiring to the AXU-MLC (/PB) circuit card.
10.
Refer to Wiring the Mini-Touch Panel for complete wiring information.
Fasten the AXU-MLC (/PB) to the BB-MTP with the #6-32 screws provided with
11.
the enclosure.
Insert the engraved overlay back into the bezel.
12.
Connect the AXlink wiring to the AMX control system and RS-232 wiring to the
13.
external RS-232 device. The AXU-MLC (/PB) will beep when you apply power.

AXU-MLC (/PB) and BB-MTP (plasterboard)

Mount the AXU-MLC (/PB) and BB-MTP (Figure 8) into a plasterboard surface (or
equivalent):
BB-MTP UniMount enclosure
Stud mounting
holes
Plasterboard surface
mounting flanges
Knockout
Expansion clips
AXU-MTP bezel
Release slot
Engraved overlay
Installing the Mini-Touch Panel 9