Note
This section pertains to touch
panels that have only 128 KB.
G3 requires that the memory
on earlier panels be upgraded
to 512 KB Standard Memory.
Figure 249
IC location on the circuit cards
Color Active-Matrix LCD Mini-Touch Panels
Memory Upgrade
Operation
You must replace the mini-touch panel's 128KB integrated circuit (IC) with a 512KB
IC to increase the storage capacity (memory) for control pages and symbols. You will
need a Phillips screwdriver and a non-conducting flat-blade tool to slip under the IC
and pry it out of its socket.
AXT-MCA (/PB) and AXT-MCV (/PB)
Figure 249 shows the location of the IC on the AXT-MCA (/PB) and AXT-MCV (/PB)
circuit cards.
P1
1
PI N _PADSTACK
PI N _PADSTACK
4
1
J2A
Connector side of circuit card
To install the 512 KB IC into the mini-touch panel:
1.
Discharge the static electricity from your body by touching a grounded object.
2.
Remove the mini-XLR AXlink connector from the rear side of the mini-touch
panel.
U24
J4
U19
1
B1
U3
32-pin socket
RAM IC
U4
B2
Memory Upgrade
169