Figure 18
Mini-TiltScreen Touch Panel
connectors (rear view)
Color Active-Matrix LCD Mini-Touch Panels
1.
Thread the incoming AXlink and video wiring through the opening in the
equipment rack.
2.
Disconnect the AXlink connectors from the Central Controller and optional video
wiring from the video source.
3.
Connect the AXlink and video wiring to the mini-touch panel circuit card. Refer
to Wiring the Mini-Touch Panels for wiring diagrams and pinout descriptions.
4.
Insert the touch panel into the equipment rack. Line up the top-left and bottom-
right screw holes and start the #6-32 screws. Then, start screwing the bottom-left
then top-right screws. Tighten all the screws after you start all the screws.
5.
Connect both the AXlink wiring to the Central Controller and video wiring to the
video source. The mini-touch panel will beep when you apply power.
Wiring the Mini-Touch Panels
The Mini-TiltScreen Touch Panels use a mini-XLR connector to supply power / data
communications, and an optional RCA connector to display PAL-, SECAM-, or
NTSC- compatible video. The UniMount and rack-mount mini-touch panels use a
four-pin AXlink connector for power and data, and an optional RCA connector to
display PAL- or NTSC-compatible video. Figure 18 shows the rear panel AXlink and
optional RCA connectors on the Mini-TiltScreen Touch Panels.
Rear view
A X link
V ideo In
RCA video connector (optional)
Mini-XLR four-pin AXlink and
power connector
Installing Mini-Touch Panels
17