Installation Procedures: 12" And 15" Panels; Overview; Unpacking The Panel; Installing Internal Components - AMX NXD-1700VG Instruction Manual

Installation Procedures: 12" and 15" Panels

Overview

NXT panels are mounted onto flat (horizontal) surfaces in either a stand-alone or combo (NXT atop an NXA-BASE/B battery base)
configuration. NXD panels are installed into either a pre-wall surface (using a CB-TP12/CB-TP15 conduit/wallbox) or a solid
surface (using either solid surface or drywall screws).
NOTE: It is recommended that if you are planning on upgrading your panel components (flash, wireless, RGB card), you do so before
beginning any panel installations.

Unpacking the Panel

1. Inspect and confirm the contents of the shipment box to verify that you have all specified parts. Refer to the Specif ications
sections on page 13 and page 15 for more information about included accessories and other AMX equipment.
2. Carefully remove the panel from the shipping box.
3. Carefully peel the protective plastic cover from the LCD.
NOTE: If the protective plastic LCD cover is not removed, the panel may not respond properly to touch points on the LCD or allow
proper screen calibration.

Installing Internal Components

Installation of the internal components such as the NXA-PCI80211G Wireless card and NXA-RGB Interface card are described in
detail within the following sections:
Step 2: Install the 802.11g mini-PCI Wireless Card section on page 34.

Step 3: Install the NXA-RGB Card Component (NXT) section on page 35.


Upgrading to the MB-TP12/MB-TP15 VESA Mounting Kit

Upgrading the existing back box with the new VESA Mounting Kit on both the 12" (FG031-50) and 15" panel (FG032-50) is
identical and requires 3 main processes:
Removing the pre-existing back box and installing the new VESA back box.

Threading cables through the strain relief grommet opening in the rear plastic cover.

Finalizing the installation of the NXD (with VESA back box and cables) into the plastic cover, securing both components, and

finalizing the strain relief grommet installation.
NOTE: The installation procedures found in this section are identical for both sizes of panels (12" and 15"). Only overall dimensions
and FG product numbers are different. The new MB-TP Universal VESA Mounting Box uses a standard VESA installation pattern of 75
mm between holes. VESA mounts that conform to this pattern can be used on the MB-TP Housing.

Removing the Original Modero Back Box

1. Detach all connectors from the side of the touch panel.
2. Remove the magnetic faceplate from the NXD unit by gripping the faceplate and pulling outwards while applying a small
amount of pressure to remove it from the main unit.
3. Place the LCD face-down on a soft cloth to expose the back of the panel and prevent scratching of the LCD.
4. Unscrew the Stereo Output nut from the Stereo Output jack.
5. Remove the I/O connector plate by using a grounded Phillips-head screwdriver to remove the two screws and slide the I/O
connector plate away from the back box housing.
6. Remove the four pan-head Housing Screws from the rear of the NXD unit (FIG. 33). These screws secure the back box to the
internal panel casing.
Modero VG Series Touch Panels - Instruction Manual
Installation Procedures: 12" and 15" Panels
44