High Current Output Mode - Teledyne 3060E Instruction Manual

Model 3060E Model 3060E Model 3060E
Model 3060E Model 3060E

High Current Output Mode

10.00 blinks in High Current m ode
VALVES: ANALYZE C=9:59
FLOW = 49.5 CC/M IN
10.00
OVERRANGE
PPM 02
AUTORANGE: HI-CURRENT
CAL STDBY SETUP
1 2 3
4-60
T=25C
O
1. If
2
If the oxygen (O
exceeds 10 PPM, the system will enter
High Current mode. The screen will
RANGE ALRM R
4 5
show
10.00
and
the concentration.
O
2. If
2
If the O
PPM for longer than two minutes, the
scrubber valves PV6 and PV7 will close
to protect the scrubber, and the Ultra
Trace sensor will be disconnected.
Every 10 minutes thereafter, the Ultra
Trace sensor will be connected for 2
minutes while O
taken.
• If the O
PPM, the scrubber valves PV6 and PV7
will open, and the Ultra Trace sensor
will continue to monitor O
• If the O
for 60 minutes, the system will shut
down automatically. This is to prevent
damage to the Ultra Trace sensor and
scrubber. Check for leaks around gas
connections and try to restart the
analyzer.
Teledyne Electronic Technologies
Analytical Instruments
> 10
PPM
) concentration level
2
-
as the range mode,
HI CURRENT
O
PPM OVERRANGE
2
> 30
PPM
concentration level exceeds 30
2
measurements are
2
level returns to levels below 30
2
.
2
level remains above 30 PPM
2
Chapter 4 Chapter 4 Chapter 4
Chapter 4 Chapter 4
as