Setup For Both Span Gas & Internal Calibrator (Full Start) - Teledyne 3060E Instruction Manual

Model 3060E Model 3060E Model 3060E
Model 3060E Model 3060E
Setup for Both Span Gas & Internal Calibrator (Full
Start)
VALVES: OFF
CAREFULLY FILL THE CALIBRATOR
W ITH A HALF CC OF CALIBRATION
ELECTROLYTE
--- PRESS ACK W HEN READY ---
1 2 3
VALVES: OFF
DO YOU WANT TO CONNECT THE
OPTIONAL SPAN GAS TANK
AT THIS TIME?
YES
1 2 3
VALVES: OFF
CONNECT THE SPAN GAS TANK
TO THE SPAN INLET
--- PRESS ACK W HEN READY ---
1 2 3
VALVES: OFF
CONNECT A SAM PLE GAS
TO THE SAM PLE PORT
--- PRESS ACK W HEN READY ---
1 2 3
VALVES: PURGE-FROM -SPAN
FLOW = 49.5 CC/M IN LOW
CHECK THE FLOW RATE FOR
150 CC/M IN
--- PRESS ACK W HEN READY ---
1 2 3
NOTE: Mass flow controller is preset to give 150 ± 3 sccm flow. However,
when a pneumatic valve does not open or the gas pressure drops to
a point where the mass flow controller is unable to deliver 150 sccm
flow, the analyzer will automatically shut down and display the
error message FLOW BELOW 20 SCCM. If this occurs, check the
sample/span gas and air pressure. Make sure that they are within
the recommended range.
4-16
15. After saying
tor, you are directed to fill the calibrator
with electrolyte. When done, press
ACK ESC
to continue or
4 5
previous screen.
16. After pressing
screen gives the option of connecting
the span gas tank. Press
NO ESC gas in addition to the internal calibrator.
4 5
17. After pressing
system directs you to connect the span
gas tank to the appropriate inlet. When
done, press
ACK ESC
4 5
18. The system directs you to connect the
sample gas tank to the appropriate inlet.
When done, press
ACK ESC
4 5
19. The system directs you to check the
flow rate for 150 cc/min and to press
when ready.
ACK
ACK ESC
4 5
Teledyne Electronic Technologies
Analytical Instruments
to the internal calibra-
YES
to return to the
ESC
in step 15, the next
ACK
to use span
YES
in step 16, the
YES
to continue.
ACK
to continue.
ACK
Chapter 4 Chapter 4 Chapter 4
Chapter 4 Chapter 4
ACK