Analog Outputs; Marker Output; Trigger In - Teledyne T3AWG3K Series Operator's Manual

Analog Outputs

The T3AWG-3K Series instrument has 2/4/8 analog output channels, each one is single-ended and the
connector type is a standard BNC.

Marker Output

The Marker Out is a digital output channel that generates a pulse related to the analog waveform. Its
impedance is 50 Ohm and the output voltage amplitude ranges from 1 V to 2.5 V into 50 Ohm load.
The Marker Out generates a digital pulse synchronous with the waveform depending on the Run Mode.
To set the Marker Out parameters refer to the Marker Out Settings.
The connector type is a standard BNC.
Marker Out Specification Value
Connector
Output impedance
Output level (into 50 Ω)
Important Note:
the Marker Out 1 is linked to the Channel 1 and Channel 2, the Marker Out 2 is linked to the Channel
Out 3 and Channel Out 4, the Marker Out 3 is linked to the Channel Out 5 and Channel Out 6, the
Marker Out 4 is linked to the Channel Out 7 and Channel Out 8.

Trigger In

The Trigger In (TRIG. IN connector on the front panel) allows to control the generation by an external
signal source. It has a selectable impedance of 1 kOhm or 50 Ohm. To know how to set the trigger
parameters or the Run Mode refer to the paragraph "Trigger In Settings". In Continuous mode the
Trigger In doesn't have any effect.
Trigger In signal (blue, top) that starts a burst of sine waveform (red, bottom)
1 BNC for each pair of channels on the Front Panel
50 Ω
1 V to 2.5 V
Model
T3AWG3352/3252
T3AWG3354/3254
T3AWG3358/3258
Trigger In Specification
Connector
Number of connectors
Input impedance
Slope/Polarity
Operator's Manual Simple AFG Application
Marker Out Connectors
1 BNC on the Front Panel
2 BNCs on the Front Panel
4 BNCs on the Front Panel
Value
BNC on the Front Panel
1
1 kΩ or 50 Ohm selectable
Positive or negative selectable
19