Setup: Zero/Span Gas Source - Teledyne 3060E Instruction Manual

Operations Operations
Operations Operations Operations

Setup: Zero/Span Gas Source

The Analyzer can be zeroed with zero gas generated by the built-in zero gas
scrubber, or by using an external zero gas. Similarly, the Analyzer can be
spanned by using the internal Faradaic calibrator or an external certified span
gas.
VALVES: ANALYZE
FLOW = 150.0 CC/M IN
5.00
AUTORANGE: 10 PPM
CAL STDBY
1 2
VALVES: ANALYZE
SELECT SYSTEM PASSW ORD SETUP
SERIAL M ODEM , ZERO GAS SCRUB
OR NEGATIVE O2 READINGS
SYSTM M ODEM
1 2
VALVES: ANALYZE
INTERNAL/EXTERNAL SELECTION
FOR ZERO GAS AND SPAN GAS
ZERO
SPAN
1 2
VALVES: ANALYZE
SELECT INTERNAL SCRUBBER OR
EXTERNAL SCRUBBER FOR ZERO GAS
INTERNAL SCRUBBER NOW IN USE
INT
1 2
VALVES: ANALYZE
SELECT INTERNAL CALIBRATOR OR
EXTERNAL SPAN GAS FOR SPAN CAL
INTERNAL CALIBRATOR NOW IN USE
INT
1 2
1. The factory default for Zero and Span
C=9:59 T=25C
PPM 02
SETUP RANGE ALRM R
3 4 5
2. Press
C=9:59 T=25C
- - OR - -
GAS NegO2 ESC
3 4 5
3. You can now select between configur-
C=9:59 T=25C
ESC
3 4 5
4. If you press
C=9:59 T=25C
EXT ESC
3 4 5
5. If you press
C=9:59 T=25C
EXT ESC
3 4 5
Teledyne Electronic Technologies
Analytical Instruments
Ultra Ultra T T T T T race Oxyg Ultra race Oxyg race Oxyg
Ultra Ultra race Oxyg race Oxygen Anal
gas source is internal. In order to
choose external Zero or Span gas press
from the Analyze mode.
SETUP
to continue.
GAS
ing zero or span gas source.
, the display gives you
ZERO
the option of choosing either the inter-
nal scrubber or an external scrubber.
The last line indicates the present
selection. Then, or
INT
to the screen in step 2.
, you can choose
SPAN
between the internal calibrator and an
external span gas. If you press
screen prompts you to fill the calibrator
with electrolyte, and
ACK
the screen in step 2. If you press
the system returns you to the screen in
step 2.
en Anal en Anal yz yzer er er er er yz yz
en Anal en Analyz
returns you
EXT
, the
INT
returns you to
,
EXT
4-55