Setup: Modem - Teledyne 3060E Instruction Manual

Model 3060E Model 3060E Model 3060E
Model 3060E Model 3060E

Setup: Modem

You can remotely locate the analyzer and view and control analyzer function
through an IBM-compatible PC using either TRACS (Teledyne Remote
Analytical Control Software) or a command set using your own communica-
tions software. The modem at the analyzer end of the operation can be prepared
for use through this menu.
Setting up the modem through the analyzer menu:
• Sets modem auto-answer.
• Sets the modem to ignore the RS-232 DSR signal.
• Sets the modem to ignore the RS-232 XON/XOFF flow control.
All three options can be set manually through the modem, but can also be set
through the analyzer for convenience.
VALVES: ANALYZE C=9:59
FLOW = 150.0 CC/M IN
5.00
PPM 02
AUTORANGE: 10 PPM
CAL STDBY SETUP
1 2 3
VALVES: ANALYZE C=9:59
SELECT SYSTEM PASSW ORD SETUP
- - OR - -
SERIAL M ODEM , ZERO GAS SCRUB
OR NEGATIVE O2 READINGS
SYSTM M ODEM GAS
1 2 3
VALVES: ANALYZE C=9:59
FOR THE SERIAL PORT SELECT
EITHER THE M ODEM
OR THE M ONITOR M ODE
M ODEM M ONTR
1 2 3
VALVES: ANALYZE C=9:59
M ODEM SETUP IN PROGRESS
1 2 3
VALVES: ANALYZE C=9:59
SERIAL PORT M ONITOR NOW ON
1 2 3
4-54
1. From the Analyze mode main menu,
T=25C
press
RANGE ALRM R
4 5
2. The next screen gives you the option of
T=25C
setting up alarms, modem, zero gas
scrubber, or negative oxygen readings.
Press
NegO2 ESC
4 5
3. Pressing
T=25C
modem search. Pressing
direct PC-to-analyzer connection
through a null modem cable.
ESC
4 5
4. While the system is looking for and
T=25C
setting up communications with the
modem or with the PC through the null
modem cable, one of these two screens
will display. When setup has been
4 5
completed, the system will beep and
T=25C
return you to the screen in step 3. Press
ESC
4 5
Teledyne Electronic Technologies
Analytical Instruments
.
SETUP
.
MODEM
initiates an automatic
MODEM
MONTR
to return to the Analyze mode.
Chapter 4 Chapter 4 Chapter 4
Chapter 4 Chapter 4
enables