Material Safety Data Sheet
Material Safety Data Sheet
Material Safety Data Sheet
Material Safety Data Sheet
Material Safety Data Sheet
Section V – Emergency and First Aid Procedures
Eye Contact:
Eye Contact:
Eye Contact:
Flush eyes with water for at least 15 minutes and get immediate
Eye Contact:
Eye Contact:
medical attention.
Skin Contact:
Skin Contact:
Skin Contact:
Skin Contact:
Skin Contact:
Wash affected area with plenty of water and remove contaminated
clothing. If burning persists, seek medical attention.
Ingestion:
Ingestion:
Ingestion:
Ingestion:
Ingestion:
Give plenty of cold water. Do not induce vomiting. Seek medical at-
tention. Do not administer liquids to an unconscious person.
Inhalation:
Inhalation:
Inhalation:
Inhalation:
Inhalation:
Liquid inhalation is unlikely.
Section VI – Handling Information
NOTE: The oxygen sensors are sealed, and under normal circumstances, the con-
tents of the sensors do not present a health hazard. The following
information is given as a guide in the event that a cell leaks.
Protective clothing:
Protective clothing:
Protective clothing:
Protective clothing:
Protective clothing:
Clean-up procedures:
Clean-up procedures:
Clean-up procedures:
Clean-up procedures:
Clean-up procedures:
Disposal:
Disposal:
Disposal:
Disposal:
Disposal:
NOTE: The above information is derived from the MSDS provided by the manu-
facturer. The information is believed to be correct but does not purport to
be all inclusive and shall be used only as a guide. Teledyne Electronic
Technologies/Analytical Instruments shall not be held liable for any dam-
age resulting from handling or from contact with the above product.
Rubber gloves, chemical splash goggles.
Wipe down the area several times with a wet paper
towel. Use a fresh towel each time.
Should be in accordance with all applicable state, local
and federal regulations.
Teledyne Electronic Technologies
Analytical Instruments
MSDS-3