Faradaic Calibrator - Teledyne 3060E Instruction Manual

Installation Installation
Installation Installation Installation

Faradaic Calibrator

The Faradaic calibrator is located inside the Ultra Trace sensor compartment.
The calibrator consists of a stainless steel block with a Teflon liner inside the
block and an electrode assembly. In order to use the Faradaic calibrator, you
must add electrolyte to the Teflon calibrator liner.
Adding the recommended amount of calibration electrolyte (about
calibrator generally enables you to use the calibrator for about 10 hours. A
countdown timer in the upper right-hand corner of the LCD keeps track of the
amount of time the calibrator has been used in a hh:mm format. A flashing
"C=0:00" on the display indicates that the calibrator needs refilling.
Figure 3-6. Sensor Cell Components and Connections
Teledyne Electronic Technologies
Analytical Instruments
Ultra T T T T T race Oxyg Ultra Ultra race Oxyg race Oxyg en Anal en Anal
Ultra Ultra race Oxygen Anal race Oxyg en Anal en Analyz
*
Some instruments have
a switch mounted here for
toggling solenoid valve 9
(see Status Panel) on and
off. See Section 3.4.3
The two wires from the switch
*
are connected so as to short
between the white/red wires
of the level detector
1
yz yzer er er er er yz yz
/ cc) to the
2
3-9