4-4. Installing and removing the bobbin case
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
4-5. Installing the bobbin
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
❸
❷
❶
2.5 cm
❹
❺
❸
❶
❷
Open hook cover ❶ .
1)
Raise latch ❸ of bobbin case ❷ , and re-
2)
move the bobbin case.
3)
When entering bobbin case, insert it with the
latch tilted until "click" sounds.
If it is not fully inserted, bobbin case
❷ may slip off during sewing.
Set the bobbin ❶ into bobbin case ❷ in the
1)
direction shown in the figure.
Pass the thread through thread slit ❸ of bob-
2)
bin case ❷ , and pull the thread as it is. By so
doing, the thread will pass under the tension
spring and be pulled out from thread hole ❹ .
Pass the thread through thread hole ❺ of the
3)
horn section, and pull out the thread by 2.5
cm from the thread hole.
If the bobbin is installed in the bob-
bin case orienting the reverse direc-
tion, the bobbin thread pulling out
will result in an inconsistent state.
– 13 –