Re-Recording Part Of A Track; Punch-In/Out; Manual Punch-In/Out - Zoom R8 Operation Manual

Re-recording part of a track (punch-in/out)
Punch-in and punch-out allow you to re-record a single part of a recorded file. The point when the
unit switches from playback to recording is the "punch-in" and the point when the unit switches
from recording to playback is the "punch-out."
The allows both manual punch-in/out using keys on the front panel or a ZOOM FS01
footswitch (sold separately) and automatic punch-in/out in which you designate the punch-in/out
points in advance.

Manual punch-in/out

You can punch-in/out manually.
During playback, press the REC key
to start re-recording from that point.
Prepare the track that you want to

punch-in/out

1
Raise the fader on the track
you want to re-record.
2
Lit red: ready to record
3
Start
Re-recorded part
32
Press the status key 1-2
times until lit red.
Adjust the recording
level and the GAIN
be the same as the
already recorded part.
Stop
Re-record by punching in and out
4
Locate to before the punch-in
point.
5
Perform (not recording)
6
Perform (recording)
7
to
8
NOTE
● Punch-in/out overwrites the recording on
the track.
● If the track is set to New Take, the track
will be silent before punching in and after
punching out.
● If the REC MODE is set to Always New, a
new file will be recorded.
● Use the UNDO soft key to cancel the
re-recording.
Press PLAY to
Lit
start playback.
Press REC to punch-in and
start recording.
Press REC to punch-out, stop
recording and start playback.
Lit
Press to stop playback
(and recording if not yet
stopped).
Unlit
Lit
Unlit