45 |
CH A P T E R 4 – R E MO T E L Y M A N A G IN G Y O U R IN T ERAC T IVE WH IT EBOA RD
SYS TE M
Source Selection Controls
These commands switch input sources. The source type determines which
commands can be accepted.
Command
get input
set input [field]
Source Selection Response Field Description
Field
VGA1
VGA2
Composite
S-Video
None
General Source Controls
The following source controls apply to all input sources. These controls are
unavailable when the projector is off. You can specify custom color values for all
inputs.
Source Information Commands
These commands inform you of the current source settings.
Command
get displaymode
get brightness
get contrast
get whitepeaking
get degamma
get red
get green
Response
input=[field]
input=[field]
Description
Switches source to the VGA 1 input connector.
Switches source to the VGA 2 input connector.
Switches source to the Composite video connector. If you
installed your interactive whiteboard system according to
the instructions, this is the relay from the ECP.
Switches source to the S-Video input connector.
A non-selectable value that appears when you enter a "get
input" command while the projector is in Idle mode.
Response
displaymode=[current display mode setting]
brightness=[current brightness setting]
contrast=[current contrast setting]
whitepeaking=[current whitepeaking setting]
degamma=[current degamma setting]
red=[current red color setting]
green=[current green color setting]
Available When
Powered Off
yes
no