Changing The Display Source For The Internal Projector - Smart Technologies SMART Board 2000i-DVX Installation Manual

To fine-tune the projected image
To automatically optimize the image in RGB mode, press the Auto Adjust button on the projector
remote control. This will eliminate vertical banding, flickering, video noise, dot interference and
cross talk.

Changing the Display Source for the Internal Projector

You can change the video and audio input source for the internal projector and cabinet audio
amplifier using the three source buttons on the control panel. Choose from the host computer, a
connected guest laptop or external computer (X-Port 20 option only) and a VCR or DVD player.
When the internal computer source is active, you can also make Notebook software or the Floating
tools appear by pressing the Notebook software button on the control panel.
VCR/DVD Player
NOTE: Switching sources takes a few seconds, and all the buttons on the control panel are
disabled during that time.
To switch to the connected VCR or DVD player
Press the VCR/DVD Player button on the control panel.
If both a VCR (composite RCA connection) and a DVD player (S-video connection) are connected
to the projector, pressing this button switches the display between the two. Press once for the
VCR; press again for the DVD player. There is a three-second delay before the alternate display
source appears.
When you switch to another source (such as the internal computer) and then press the VCR/DVD
Player button, the video source that was last active appears. For example, if you were viewing a
DVD, and then switched to the computer, the DVD player will be the display source the next time
you press the VCR/DVD Player button.
To switch to the internal computer
Press the Internal Computer button on the control panel.
38
Internal Computer
Notebook Software
Basic Operations
Guest Laptop