Using Your Remote Control; Installing The Remote Control Battery - Smart Technologies SMART Board 600i4 Configuration And User's Manual

To access or replace the
remote control battery
22 | CH A P T E R 3 – U SIN G Y O UR IN T ER ACT IV E WH IT EB OARD SY ST EM

Using Your Remote Control

The SMART UF65 or SMART UF65w projector remote control enables you to access
on-screen projector menus and change projector settings.

Installing the Remote Control Battery

Follow this procedure to use the remote control for the first time or to replace the
remote control battery.
WARNINGS
• Reduce the risk associated with a leaking battery in the projector's remote
control by following these practices:
– Use only the specified coin-cell type battery.
– Orient the battery's plus (+) and minus (-) terminals according to the
markings on the remote control.
– Remove the battery when the remote control is unused for an extended
period.
– Do not heat, disassemble, short or recharge the battery, or expose it to
fire or high temperatures.
– Avoid eye and skin contact if the battery has a leak.
• Dispose of the exhausted battery and product components in accordance with
applicable regulations.
1. Hold down the side release on the left side
of the battery holder and pull the battery
holder completely out of the remote control.
2. Remove the plastic sheet inside the battery
holder, and then insert a CR2025 coin cell
battery into the battery holder.
TIP
Make sure that the positive (+) and
negative (-) signs on the battery
terminals align with the correct signs
on the battery holder.
3. Re-insert the battery holder into the remote control.