Smart Technologies SMART Board 600i4 Configuration And User's Manual page 108

To remove and replace
the projector lamp module
92 | CH A P T E R 7 – R E P L A C I N G T H E S M A R T U F 6 5 O R S M A R T U F 6 5 W P R O J E C T O R
LA MP
You require a Phillips No. 2 screwdriver to perform the following procedure.
1. Remove the outer lamp cover with your finger and set it aside.
2. Using a Phillips No. 2 screwdriver, loosen the two screws on the inner lamp
module. The screws remain captive inside the lamp module.
3. Pull up on the lamp module's handle, and then remove the lamp.