To replace the lamp
module and lamp cover
86 |
CH A P T E R 6 – M A I N T A I NI NG Y O U R I NT E R A C T I V E W H I TE BO A R D S Y S T E M
2. Thoroughly vacuum the three top vents, the lamp slot and the I/O panel vent
on the projector as indicated in the following images for 10 seconds each.
Replacing the Lamp Module and Lamp Cover
After you vacuum the lamp module and projector vents, replace the lamp module and
cover.
1. Place the lamp module back in the lamp slot, push the lamp all the way down, and
then tighten the lamp locking screws until they're secure.
2. Replace the outer lamp cover.
Vents
Lamp Slot
I/O Panel Vent