Network Controls - Smart Technologies SMART Board 600i4 Configuration And User's Manual

50 | CH A P T E R 4 – R E MO T E L Y M A N A G IN G Y O U R IN T ERAC T IVE WH IT EBOA RD
SYS TE M

Network Controls

These commands control your projector's network status and settings. These settings
are always available, even when the projector is off.
Network Information Commands
These commands inform you of the current network settings.
Command
get netstatus
get dhcp
get ipaddr
get subnetmask
get gateway
get primarydns
get macaddr
Network Control Commands
These commands control your network settings.
Command
set dhcp [target]
set ipaddr [target]
set subnetmask [target]
set gateway [target]
set primarydns [target]
Response
netstatus=connected
netstatus=disconnected
netstatus=disabled
dhcp=[current DHCP status]
ipaddr=[current IP address]
subnetmask=[current subnet work mask number]
gateway=[current network gateway]
primarydns=[current primary domain name number]
macaddr=[current MAC address]
Command Target Range Response
=on
=off
=0.0.0.0 to
=255.255.255.255
=0.0.0.0 to
=255.255.255.255
=0.0.0.0 to
=255.255.255.255
=0.0.0.0 to
=255.255.255.255
dhcp=[current]
ipaddr=[current]
subnetmask=[current]
gateway=[current]
primarydns=[current]