Smart Technologies SMART Board 600i4 Configuration And User's Manual page 109

93 | CH A P T E R 7 – R E P L A C I N G T H E S M A R T U F 6 5 O R S M A R T U F 6 5 W P R O J E C T O R
LA MP
4. Put the old lamp in a secure container. Handle the old lamp gently until you
recycle or dispose of it.
IMPORTANT
Recycle or dispose of the lamp module according to your local
waste authority.
5. Remove the replacement lamp module from its packaging.
CAUTION
Do not touch any part of the lamp module except the housing.
6. Place the replacement lamp module in the lamp slot, push the lamp all the way
down, and then tighten the lamp locking screws until they're secure.
7. Replace the outer lamp cover.
NOTE
You may need to adjust the projected image after performing the previous
procedures. For more information, see the included
D600i4 Interactive Whiteboard System Installation Instructions
page 16.
8. Replace the projector on the boom and connect the cables. See page 87.
SMART Board 600i4 and
and the tips on