Table of Contents
Advertisement
2. Press and hold the Volume Down (
for the current source.
To restore the default volume level (no sound)
Press and hold both Volume buttons simultaneously.
To fine-tune the projected image
When you first use the projector, you may need to fine-tune the projected image. To automatically
optimize the image in RGB mode, press the Auto Adjust button on the projector's remote control (or
on the projector). This will eliminate vertical banding, flickering, video noise, dot interference and
cross talk, and may be necessary the when you connect the computer for the first time.
Changing the Display Source for the Internal Projector
You can change the video and audio input source for the internal projector and cabinet audio
amplifier using the three source buttons on the Control Panel. Choose from the host computer, a
connected guest laptop or external computer (X-Port 20 switch option only) and a VCR or DVD
player. When the internal computer source is active, you can also open Notebook software and the
SMART Board tools by pressing the Notebook software button on the Control Panel.
VCR/DVD Player
NOTE: Source switching takes a few seconds, and during that time all buttons on the Control Panel
are disabled.
To switch to the connected VCR or DVD player
Press the VCR/DVD Player button on the Control Panel.
NOTE: You can't use the VCR/DVD Player button to switch to a VCR or DVD player that's connected
by an S-video cable. You must use the projector remote control to switch to an S-video source.
To switch to the internal computer
Press the Internal Computer button on the Control Panel.
To switch to a guest computer (X-Port 20 switch option only)
Press the Guest Laptop button on the Control Panel.
–
) button on the Control Panel to decrease the volume
Internal (Host) Computer
Guest Laptop
Notebook
Software
2000i-DVX Installation Guide
33
Advertisement
Table of Contents
