Smart Technologies SMART Board 600i4 Configuration And User's Manual page 68

52 | CH A P T E R 4 – R E MO T E L Y M A N A G IN G Y O U R IN T ERAC T IVE WH IT EBOA RD
SYS TE M
System Information Commands (Passive)
These commands inform you of the current system settings. These commands are
always available, even when the projector is off.
Command
get lamphrs
get syshrs
get fwverddp
get fwvernet
get fwvermpu
get fwverecp
get vgaoutnetenable
System Control Commands (Active)
These commands control the current system settings. These commands are
unavailable when the projector is off. See page 42 for setting absolute and adjustment
commands.
Command
set autosignal [target]
set lampreminder [target]
set highbrightness [target]
set autopoweroff [value]
set zoom [value]
set projectorid [value]
set hposition [value]
set vposition [value]
set aspectratio [target]
Response
lamphrs=[current lamp hours of operation]
syshrs=[current projector hours of operation]
fwverddp=[current projector firmware version]
fwvernet=[current network firmware version]
fwvermpu=[current processor firmware version]
fwverecp=[current ECP firmware version]
vgaoutnetenable=[current]
Command Target
Range
=on
=off
=on
=off
=on
=off
=0 to =240
=0 to =30
=0 to =99
=0 to =100
=-5 to =5
=fill
=match
=16:9
Response
autosignal=[target]
lampreminder=[target]
highbrightness=[target]
autopoweroff=[value]
zoom=[value]
projectorid=[value]
hposition=[value]
vposition=[value]
aspectratio=[target]