Smart Technologies SMART Board 600i4 Configuration And User's Manual page 100

84 | CH A P T E R 6 – M A I N T A I NI NG Y O U R I NT E R A C T I V E W H I TE BO A R D S Y S T E M
Accessing the Lamp Module
To access the lamp module, remove the lamp cover, and then remove the lamp from
the projector.
To remove the lamp cover 1. Pull off the outer lamp cover with your finger and set it aside.
and lamp module
2. Using a Phillips No. 2 screwdriver, loosen the two screws on the inner lamp
module. The screws remain captive inside the lamp module.