Projector Ready Lights And Projector Status - Smart Technologies SMART Board 600i4 Configuration And User's Manual

66 | CH A P T E R 5 – T R O U B L E S H O O T I N G Y O U R IN TE RAC T IVE W H I T E B O A R D
SYS TE M
Interactive
Whiteboard Status
Ready Light
Flashing green Your interactive whiteboard is on and communicating with your
computer, but it's in Mouse mode. Confirm that SMART Product
Drivers is installed on your computer.
Flashing amber Your interactive whiteboard system is turning on, is in service
mode or has detected a firmware error. On the projector's
input/output panel, check the ECP's 4-pin powered-mini-DIN
connection. If nothing changes after you check your connectors,
call your
Projector Ready Lights and Projector
Status
The SMART UF65 or SMART UF65w projector's two indicator LED lights (Power and
Service) are located on the boom-mounted projector. Specific light sequences convey
information about the state of the projector, including errors.
IMPORTANT
After you resolve the projector's issue, disconnect and then reconnect the
projector power cable to clear the indicator light sequence, and then reset the
projector's status.
Power LED Service LED
(Green/Amber) (Red)
Solid amber Off
Flashing green Off
Solid green Off
Flashing amber Off
Off Flashing red
authorized SMART reseller.
Message
The projector is off but still receiving power
(Idle mode). Press the power button
to turn it on.
The projector is in the powering (startup) power
state. Wait for the projector to finish powering on.
The projector is in the operating (on) power state.
Press the power button on the ECP twice to turn
it off.
The projector is in the cooling power state. Wait for
the projector to finish cooling.
The projector is overheating. The projector might
shut down automatically. See The "Projector
Overheated" Message Appears on page 68 to
troubleshoot the projector.
on the ECP