Smart Technologies SMART Board 600i4 Configuration And User's Manual page 57

41 |
To configure 1. Turn on your computer, and then start your serial communications program or
your computer's
serial interface
2. Connect your computer to the serial connection cable you previously attached to
3. Configure your serial interface settings using the values in the table in the
4. Type commands to configure your settings.
CH A P T E R 4 – R E MO T E L Y M A N A G IN G Y O U R IN T ERAC T IVE WH IT EBOA RD
SYS TE M
NOTES
• Asynchronous mode is disabled by default in the projector.
• All commands should be in ASCII format. Terminate all commands with a
carriage return.
• All responses from the projector are terminated with a command prompt.
Wait until you receive the command prompt, indicating that the system is
ready for another command, before proceeding.
• The room control feature of the projector is always on.
terminal emulation program.
the projector.
previous section, and then press ENTER.
An "invalid cmd= ? for help" message appears, and the > character appears as a
command prompt on the following line.
NOTE
If no message or an error message appears, your serial interface
configuration isn't correct. Repeat step 3.
NOTES
– To see a list of available commands, type ? and then press ENTER.
– When you're using a terminal emulation program, turn on your program's
local echo setting if you want to see characters as you type them.