Sensor Removal; Bottom Plate - Epson EPL-9000 Service Manual

Service Manual
3.2.4.10

Sensor Removal

1. Remove the top cover. (Refer to Section 3.2.1.2.)
2. Remove the left cover. (Refer to Section
3 Remove the
4. Remove the trans. chute assembly. (Refer to Section 3.2.4.7.)
5. Remove the link assembly. (Refer to Section
6. 5 screws
7. Remove screw
8. Discomect connector
3.2.4.11 Bottom Plate Removal
Remove the top cover. (Refer to Section 3.2.1.2.)
1.
Remove the left cover. (Refer to Section 3.2.1.3.)
2.
3 Remove the BTR assembly. (Refer to Section 3.2.4.4.)
4. Remove the trans. chute assembly. (Refer to Section 3.2.4.7.)
5. Remove the link assembly. (Refer to Section 3.2.4.1.)
6.
Remove 5 screws
7. Remove 2 springs from the bottom plate.
8.
Remove screw
removing the support bracket.
Figure 3-34. Removing the
Rev.
(Refer to Section 3.2.4.4.)
x 8) securing the front frame assembly to the front cover.
x 8) securing the
from the sensor.
Figure 3-33. Removing
x 8) securing the front frame assembly to the front cover.
x 6) securing the support bracket, and remove the bottom plate after
Disassembly and Assembly
sensor, and remove it.
the Sensor

Bottom Plate

3-21