Table of Contents
Advertisement
Frequency Controls
The crossover frequency (xF) between the bands and the center frequency (cF)
of the Mid bands is shown at the bottom of the EQ Display (see
on page
The frequencies for each band can be modified by entering the values directly
and by manipulating the colored band curves.
Frequency
Values
All band frequency values are always displayed. Values can be input directly
using text entry (see
If a value is entered that is outside of the minimum and maximum allowable
value, the entry field will not accept the change and the value for the entry
field will remain unchanged.
For the center frequencies, if a value is entered that is still within the accept-
able min/max range but the center frequency can not reach the input value
because it would require a change to the width, then the nearest allowable
value is set. If a lower or greater center frequency value is desired (i.e., the
original center frequency value attempt), the width of the band must be re-
duced first, then the center frequency adjusted again. It's easiest to see the cF
limits at the given width by dragging the center frequency with the mouse.
To modify the frequency (and gain) values using the EQ Display, see
Control Points" on page
UAD Powered Plug-Ins Manual
468).
"Text Entry" on page
468).
92).
- 470 -
"EQ Display"
"Curve
Chapter 46: Precision Multiband
Advertisement
Table of Contents
