Table of Contents
Advertisement
• Compensating for upsampled UAD plug-ins is not required when these plug-
• If only one latency value is shown in
• UAD Pultec-Pro only requires one compensation per instance. For example,
• Since the maximum Samples value in one DelayComp instance is 128,
• Latency compensation techniques for upsampled plug-ins apply to UAD
• The latency in
• Upsampled plug-in latency cannot be displayed in the
UAD Powered Plug-Ins Manual
ins are used for program material on the output bus, where latency is not a
consideration.
plies to both UAD–1 and UAD-2. N/A means that sample rate is not sup-
ported.
if using both MEQ-5 and EQP-1A within a single Pultec-Pro, only one in-
stance compensation is required.
more than one DelayComp instance will be required (in series) if the com-
pensation value from
Track Advance
(page
Table 7 on page 110
(page
89) is used with upsampled plug-ins.
tion" on page 66
due to technical limitations.
Table 7 on page
Table 7 on page 110
113) as well.
is also produced when LiveTrack mode
- 109 -
110, the value ap-
exceeds 128.
"Plug-In Latency Sec-
Chapter 9: UAD Delay Compensation
Advertisement
Table of Contents
