Table of Contents
Advertisement
Hz Frequency
Hz Solo isolates the original bass signal and can be combined with Ef-
Hz Solo
fect Solo. Hz Solo is active when the button is red.
Output
after the desired amount of processing is achieved with the Effect and Hz Fre-
quency controls. Output does not affect the amount of enhancement process-
ing, nor does it have any effect when the plug-in is disabled.
Output Meter
The stereo Output Meter displays the signal level at the output of the plug-in.
When the plug-in is disabled with the plug-in Power switch (but not the host
plug-in enable switch), the output meters still function.
Power
Toggle the switch or click the UA logo to change the Power state. The UA logo
is illuminated in blue when the plug-in is active.
Note:
compare the enabled/disabled state.
UAD Powered Plug-Ins Manual
Through filter isolation of the original bass content,
the Hz Frequency parameter defines the cutoff fre-
quency for the enhancement process. Frequencies be-
low this value are enhanced by the processor. The
available range is 16 Hz to 320 Hz.
The Power switch determines whether the plug-in is active. This
is useful for comparing the processed settings to the original
signal or bypassing the plug-in to reduce the UAD DSP load
(load is not reduced if
enabled).
You can click-hold the power switch then drag it like a slider to quickly
Output controls the signal level that is output
from the plug-in. The available range is –20
dB to 0 dB.
Generally speaking, adjust the Output control
"UAD-2 DSP LoadLock" on page 74
- 434 -
Chapter 41: Precision Enhancer Hz
is
Advertisement
Table of Contents
