Universal Audio UAD User Manual page 297

Powered plug-ins software version 6.1
Table of Contents

Advertisement

When configured as mono-in/mono-out ("MIMO"), output A is used exclu-
sively except in programs 2, 4, and 9, where outputs A and C are summed
into one monophonic signal. This implementation is recommended in the orig-
inal hardware manual. If Rear Outs is enabled in MIMO mode, outputs B and
D are used instead of A and C. See
used with each program in this configuration.
Primary &
The primary controls (those that are most typically used) are on the main "re-
Hidden Controls
mote control" panel interface. Additional (less typically used) controls are
available in a hidden control panel. The hidden control panel
page
Display Panel.
For detailed descriptions of all parameters, see
page 299
The parameter value ranges, default values, and availability of particular pa-
Parameter
Ranges &
rameters within a given program may vary depending on which program is
Default Values
active. Parameter ranges are listed in the individual control descriptions. De-
fault parameter values for each program are listed in
Note:
cause other unexpected sounds. This behavior is identical to the original hard-
ware.
Display Panel
The Lexicon 224 display panel
ements: Numerical Value, LED Value, Stereo Level Meters, and Overflow in-
dicator. Exactly what is displayed here is dependent on the parameter being
edited (if any) and the state of the
Figure 100. The Lexicon 224 Display Panel
Numerical Value
The three-character Numerical Value Display shows the value of parameters
as they are being edited. The value of the edited parameter is displayed for
1.5 seconds unless the
last edited parameter value continues to be displayed.
UAD Powered Plug-Ins Manual
306) is accessed by clicking the "OPEN" text label to the right of the
and
"Hidden Controls" on page
Extreme parameter settings can cause Lexicon 224 to self-oscillate or
Display Hold
Table 21 on page 311
"Primary Controls" on
306.
(Figure 100
below) consists of four display el-
Display Hold
switch
switch is set to infinite, in which case the
- 297 -
for a list of outputs
(Figure 102 on
Table 22 on page
311.
(page
308).
Chapter 27: Lexicon 224

Advertisement

Table of Contents
loading

Related Products for Universal Audio UAD

This manual is also suitable for:

Uad powered plug-ins

Table of Contents