Table of Contents
Advertisement
Adjusting Gain
Adjusting Gain
and cF
Adjusting Gain
and Bandwidth
Adjusting xF
Note:
eters
UAD Powered Plug-Ins Manual
The gain of a band can be adjusted by click-drag-
ging the top of its colored line. In this case the cursor
changes to an up/down arrow when hovered over
the hot spot to indicate the direction available for
dragging.
If the cursor is moved slightly lower than the above ex-
ample, the gain and center frequency can be ad-
justed simultaneously, without adjusting the band-
width. In this case the cursor changes to an
up/down/left/right arrow when hovered over the hot
spot to indicate the direction available for dragging.
If the cursor is moved to the upper-left region of the
three center bands (LMF, MF, HMF), the gain and
bandwidth can be adjusted simultaneously, without
changing the center frequency. In this case the cursor
changes to a diagonal arrow when hovered over the
hot spot to indicate the direction available for drag-
ging.
If the cursor is moved to where two bands crossover,
the crossover frequencies can be adjusted, without
changing the gain or center frequency. In this case
the cursor changes to a left/right arrow when hov-
ered over the hot spot to indicate the direction avail-
able for dragging.
Frequencies can also be adjusted by using the Frequency Value param-
(see"Frequency Values" on page
470).
- 469 -
Chapter 46: Precision Multiband
Advertisement
Table of Contents
