Table of Contents
Advertisement
Table 16. Compressor Mode LED States
Compressor Mode LED State
All Unlit
Green
Yellow
Green + Yellow
Red
Red + Green
Red + Yellow
Red + Green + Yellow
The Gain Reduction Meter displays the amount of gain reduction occurring
GR Meter
within the FATSO compressor, expressed as negative dB values.
Note:
curring even when the compressor is disabled. This behavior is identical to the
hardware unit.
Warmth
Warmth, as indicated by the Warmth Meter.
Values of 1 to 7 are available. The current value is indicated by the arc of
Warmth LED's. Warmth is off when all LED's are unlit.
The Warmth Meter is a very accurate display of the amount of high frequency
Warmth Meter
attenuation, as defined by the Warmth button. The meter shows the amount of
HF gain reduction occurring at 20 kHz.
Note:
when Warmth is disabled. This behavior is identical to the hardware unit.
UAD Powered Plug-Ins Manual
At extreme settings, the GR Meter may indicate gain reduction is oc-
This button defines the Warmth amount. Warmth simulates
the softening of the high frequencies that occurs with analog
tape saturation (see
detailed Warmth description). Higher values increase the
At extreme settings, the Warmth Meter may indicate activity even
Active Compressor Mode(s)
Compressor inactive
Buss
General Purpose (G.P.)
Tracking (most versatile ratio)
Spank
Spank + Buss
Spank + General Purpose
Spank + Tracking
"Warmth Processor" on page 223
- 227 -
Chapter 18: Empirical Labs EL7 FATSO
for
Advertisement
Table of Contents
